Most people never give their water heater a second thought till it stops working. One thing you can perform to prolong the life of the water heater is to drain the tank annually to remove any sediment that may have build up inside it. Most water heaters employ a large, insulated holding tank to ensure there's plenty of hot water on hand at all times for different purposes throughout the home. With time, naturally occurring minerals in the water, as well as sand and grit flushed from municipal water lines, can settle in the bottom of the tank. This sediment build-up may potentially decrease the efficiency and total capacity of your water heater. It can also plug the drain and affect with ongoing maintenance, which leads to early failure.
Deposit can interfere with burner efficiency in a gas water heater and can produce cracking and popping noises during heating cycles. Based on your water source and the mineral content, both gas and electric water heaters should preferably be flushed of sediment every 1-2 yrs to ensure optimal performance.
Step 1: Turn Off the Water Supply
Turn off the cold water supply valve at the top of the water heater
Step 2: Turn Off the Water Heater
For a gas water heater, turn the thermostat to the "pilot" setting.
For an electric water heater, turn off the electricity at the breaker box.
Note: Electric water heaters have to be turned completely off during flushing. Exposed heating elements can quickly burn out when the water level in the tank falls below the level of the hot elements.
Most electric water heaters are wired directly to their own circuit breaker. Find the water heater's breaker button in the main electrical panel.
Step 3: Attach Hose to Drain Valve
Near the base of the tank, locate the tank drain valve and connect a standard garden hose to the drain valve. Be advised that some models may have a cover over the valve opening. Place the other end of the garden hose in a floor drain or on a driveway where it can drain safely. If required, pails can be used, but be cautious not to be burned by the hot water as you work.
Step 4: Open Hot Water Tap
Open a hot water tap closest to the water heater, preferably on the floor above. This reduces pressure in the system, enabling the water to drain quickly from the tank, much like removing your finger from the top of a drinking straw filled with liquid.
Step 5: Open Drain Valve
Open the drain valve and let the water to drain from the tank. Again, the water will be hot, so use caution. Once all water has drained from the tank, briefly turn the cold water supply on to the tank. This will stir up any remaining sediment. Repeat this procedure until the water runs clear.
Step 6: Close Drain Valve, Refill Tank, Turn Water Heater Back On
Close the drain valve, remove the hose, and turn on the cold water supply. The tank will start to fill. Go back to the hot water tap opened earlier. Once cold water starts to flow from the tap, turn it off. Turn the gas valve back on from the pilot position or turn electricity back on to the tank. Be sure to check the valve opening when it's closed to ensure there are no water leaks.
Caution: Some tanks must be completely full to prevent damage to the gas burner or heating elements. Always read and follow all manufacturer's instructions and warnings for your particular water heater.
Your Local Sacramento HVAC Business
No comments:
Post a Comment